<noframes id="bznnl"><sub id="bznnl"></sub>

          <noframes id="bznnl"><menuitem id="bznnl"><font id="bznnl"></font></menuitem>

              Contact us
              Add: Ouhai District, Wenzhou District, District, the town of Pan Bridge, No.

              Home > News > Company news > How should tube clip device

              Company news
              • How should tube clip device

                Time: 2015-8-27 9:38:50

              • Means the board before soldering equipment, which is very well determine the direction of the folder, advocate first good sign in a fixed place, after welding, welding, pipe clamps fitted on the lower half of the body some, the need to put a fixed pipe. Put on another half pipe clamp body and the cover screwed tight. Avoid direct soldering has been installed floor pipe clamps. An on board to guide rails can be welded on the foundation, or with screws, then push the inside rail nut orbit and turn 90 degrees and the lower half of the body embedded tube clamp nut, put the need fixed pipe, add the upper half of the pipe clip body and cover with screws. Stack up means on the basis of the rail may be welded or fixed with screws, first with the upper and lower half of the pipe clamp body, need to put on a fixed pipe and put on half pipe clamp body, with screws, through the locking plate avoid it changes. Then a second tube clamp means, way above. Bending device when device elbow, should be directly in front and rear elbow pipe clamp with Site Di pipe clamps. Such claims should be fixed bearing support point.
              • Prev: What is a hydraulic filter
                Next: No information
              • Close

              Links: Lianke  Feedback | Products | Contact us |

              Copyright ? 2015 Huayu Hydraulic All Rights Reserved.